Die Design

Table of Contents

Select a lesson or start at the beginning.

• Introduction
• Lesson 1                       In-Class Bend Allowance Example
• Lesson 2
• Lesson 3
• Lesson 4                      Bending Die Website at Ohio State's Engineering Research Center (ERC)
• Lesson 5
• Session 6: Midterm #1
• Session 7: Plant Tour
• Lesson 8
• Lesson 9
• Lesson 10
• Session 11: Open Lab    In-Class Spring Selection Example
• Session 12: Open Lab
• Session 13: Midterm #2
• Lesson 14
• Lesson 15  Draw Die Design Example
• Lesson 16  Part No. 258-3 Assignment